Skip to toolbar

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
#125749
PHILSON
Participant
@philson

Thanks for the info! Hopefully I can get a hold of Cornishtiger to speak in more detail about actually getting this done.

ArniVidar;112039 wrote:
Cornishtiger, our resident laser expert, can probably give you a rough guesstimate for a price, but I’d think it shouldn’t be too expensive. Seeing as it’s so tiny,(surely they must charge (relatively thinking) per inch or square inch or something like that) it can’t take more than a couple of seconds each session and thus can’t be too expensive (not that I have the foggiest idea).
#125687
PHILSON
Participant
@philson

The artist also was clearly using tight rounds and the needle grouping of the needle bar was rather large since we were doing the 8-bit therein causing a much thicker line than if he were to be using a smaller grouping or (I wish) a single needle…

#125686
PHILSON
Participant
@philson

Here is the tattoo…Link has a limp sword I know it is not that bad, but i would just have to have that lasered off I guess…I just hate having one piece that is not complete, an it is supposed to be in full 8-bit color (SNES Link sprite). here it is: aauus.jpg I know the story is much better than the results, I’m glad the damage was minimal, but still surprised the slide of his hand was able to create a line that long! Dude was tripping when she busted in and DUG into my skin, if you see it close up or higher res. the first point where he derived to botch it has some scarring under it cause it went straight through the epidermis…So you guys really think just laser off that part of the tattoo? How many sessions would you guys estimate that is? Cost as well?? Anything at all would be greatly appreciated!!

Viewing 3 posts - 1 through 3 (of 3 total)
Lost Password

PHILSON

Profile picture of PHILSON

@philson

Not recently active